To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3761 (-5)
  Working with a different compiler 2
 
Howdy All, I am in a happy mood today. I finally got to the 'hello world' stage. All I had to do was count the number of interrupts, * 2 (16 bit addresses), subtract this from BFFF which is the reset vector and thus supply BFD6 to my linker to start (...) (29 years ago, 4-May-98, to lugnet.robotics.handyboard)
 
  Re: LCD Addressing - & - Expanded Mode
 
From the driver code I recently sent out: * LCD Connections on the Handyboard * PORTB bit 0 - R/W * PORTB bit 1 - RS (Register Select, 0 = instruction) * PORTC 8 bits of Data * PORTA bit 4 - E clock (...) That is correct, the LCD is NOT memory (...) (29 years ago, 4-May-98, to lugnet.robotics.handyboard)
 
  Re: dc motor blues
 
Hi All; Along the same lines, I would LOVE to control my motors so they run at constant speed under varying load. I know that it's theoretically possible to sense the RPM of a PM DC motor by tracking the drive voltage as the commutator makes and (...) (29 years ago, 4-May-98, to lugnet.robotics.handyboard)
 
  RE: Connections
 
Hmm... I had the same problem and made an only mildly inelegant kludge with straight and right-angle headers. How much do you enjoy soldering? Seriously, does anyone know of any single-row intraconnectors? Brett Anthony Research Technician School of (...) (29 years ago, 4-May-98, to lugnet.robotics.handyboard)
 
  Re: Cannot download pcode on a Mac G3
 
(...) Yes. Using the same set of boards, I can download pcode using IC 3.1 as well as IC 2.xxx from my old macintosh Centris 650 as well as from Performa 6100. -Paul (29 years ago, 4-May-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR