 | | Re: Polarity of PowerJack from HB und Charger Board
|
|
on the interface/charger, since there's a bridge rectifier immediately normalizing the input jack voltage -- regardless of polarity -- it kind of doesn't matter which polarity you use. there is a discrepancy between the int/charger schematic and (...) (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Cannot download pcode on a Mac G3
|
|
Paul -- have you tried 6811 Downloader? Any luck with that? looks like Randy and I will both need to get our hands on a G3 to debug our code :-) Fred In your message you said: (...) (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
|
| |
 | | Cannot download pcode on a Mac G3
|
|
Hello everyone, I've been having a problem downloading pcode to a handyboard or rugwarrior board from my Mac G3 (266 Mhz desktop model). When I try to download the bootstrap code, it reports that the bootstrap failed after 000 bytes, etc.. etc... (...) (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
|
| |
 | | Controlling a DC motor 3
|
|
Thank your for all your replies, I understand what 's going on now Another question about the motor driver is: Q) The PWM is a sequence of pulses switching on & off the H-Bridge. But what should be the rate of PWM? 1000Hz?? why? what does the rate (...) (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
|
| |
 | | LCD Addressing - & - Expanded Mode
|
|
Two questions: 1) I'm having a little trouble figuring out how the LCD is addressed. It uses A8 and A8 but also is clocked from Port A. Can someone explain how to properly address the LCD using ASM? 2) The Mode B pin is always grounded. How does the (...) (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
|