To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3741 (+5)
  recharging a battery the right way
 
hello I have a 6v 2.0amp battery. Its a lead acid battery. What is the right way to recharge it? The reason I ask is because I had a 12v 7amp battery from the same manyfacturer. I charged it using a car battery charger at the lowest setting (...) (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
 
  LCD Addressing - & - Expanded Mode
 
Two questions: 1) I'm having a little trouble figuring out how the LCD is addressed. It uses A8 and A8 but also is clocked from Port A. Can someone explain how to properly address the LCD using ASM? 2) The Mode B pin is always grounded. How does the (...) (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
 
  Controlling a DC motor 3
 
Thank your for all your replies, I understand what 's going on now Another question about the motor driver is: Q) The PWM is a sequence of pulses switching on & off the H-Bridge. But what should be the rate of PWM? 1000Hz?? why? what does the rate (...) (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
 
  Cannot download pcode on a Mac G3
 
Hello everyone, I've been having a problem downloading pcode to a handyboard or rugwarrior board from my Mac G3 (266 Mhz desktop model). When I try to download the bootstrap code, it reports that the bootstrap failed after 000 bytes, etc.. etc... (...) (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
 
  Re: Cannot download pcode on a Mac G3
 
Paul -- have you tried 6811 Downloader? Any luck with that? looks like Randy and I will both need to get our hands on a G3 to debug our code :-) Fred In your message you said: (...) (29 years ago, 3-May-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR