To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3666 (+5)
  Re: Help!! Polaroid problem!!!
 
Are you using a pullup resistor on the ECHO pin? If not that is your problem. The ECHO output is an open collector driver which requires an 4.7 K pull-up resistor between the output and Vcc. The pull-up is necessary for connecting the module to a (...) (29 years ago, 21-Apr-98, to lugnet.robotics.handyboard)
 
  Handy board help
 
I am interested in using the Handy Board, but I have a few questions about it first. Please help. :) I noticed the Handy Board supports 4 motors but I am interested in using stepper motors with it. Is this possible? If so what modifications would be (...) (29 years ago, 21-Apr-98, to lugnet.robotics.handyboard)
 
  tsl1301 or 1401
 
Has anyone tried to use one of the TI tsl1301 or 1401 linear sensors with the HB. I ended up with a few but am having a tough time trying to figure out what the data sheets are trying to tell me. Not real clear (to me). Bruce A. Moore (29 years ago, 21-Apr-98, to lugnet.robotics.handyboard)
 
  Re: Help!! Polaroid problem!!!
 
Why does it seem like everyone except me needs a pullup resistor and perhaps a capacitor somewhere to operate the Polaroid? I've never had any problems without any of these components. ??? The first time I connected the sensor, it worked perfectly. (...) (29 years ago, 22-Apr-98, to lugnet.robotics.handyboard)
 
  To Prof. Fred Martin: Neat!
 
Hi, I saw your robot at the Trinity fire fighting contest last Sunday. It was neat, and very animate. I was curious to know if you had figured out why it did what it did during your first run (?). And, what type of sensor were you using on the rear (...) (29 years ago, 22-Apr-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR