 | | Re: Interesting BrickOS Timing Results
|
|
Mark, I retrieved the latest BrickOS from CVS, made clean and made the cpu test program you listed. I then made two small changes (to see what would happen); first the results, then the changes: IDLE: 89 2ROT: 87 NOAD: 91 (see below) NIRQ: 98 (see (...) (24 years ago, 15-Jan-03, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: Land mine robot
|
|
(...) Or make your own. "Passive" sensors have a 5V constant current, and the raw value is the resistance, scaled so infinite resistance is 1023. "Active" sensors can draw more power, but I don't know anything about them. (24 years ago, 15-Jan-03, to lugnet.robotics)
|
| |
 | | Re: Interesting BrickOS Timing Results
|
|
(...) The delay was added a long time ago after a bit of discussion on this newsgroup/list. A search through old newsgroup posts will turn up a brief series of three posts with subject "Rom sensor read routine" from Apr/May 1999. The explanation (...) (24 years ago, 15-Jan-03, to lugnet.robotics.rcx.legos)
|
| |
 | | Patches on SourceForge? A good/bad way to get changes into brickOS?
|
|
I've just posted (URL) note that there are 4 other patches lingering from as far back as September. Will my patch be looked at because it has been posted there? For info, here is the patch description The last version of binutils that brickOS works (...) (24 years ago, 14-Jan-03, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: I2C device for the RCX
|
|
(...) Lepomux works with a serial protocol (5 bit preamble, 8 bit data, parity) based on a halfbit-clockspeed of 1 kHz. So compared to your I2C-driver it is dead slow (about 33ms/byte = 30 bytes/s). This slow speed has two reasons: - it's possible (...) (24 years ago, 14-Jan-03, to lugnet.robotics)
|