 | | Re: 68HC811E2
|
|
Thanks John, but I can't believe that, it must be a way there, to alter the CONFIG register ! Erwin (...) (29 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Servos
|
|
(...) This won't work, as the servo's require a one-shot, not a variable duty cycle type of pwm (like what comes from the motor drivers on the HB). ie. the width of any given pulse is not consistent, just the overall duty cycle. RC servo's require a (...) (29 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: 68HC811E2 Can't be set
|
|
I ran into the same problem. I was unable to set it with any of the utilities for the handyboard. I ended up using my mini-board and its download software to correctly set the register. I don't know why it worked. Andy hobbytec@cas.auracom.com (...) (29 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
|
| |
 | | RE: Need help finding a A1 chip.
|
|
Try BG Micro, 1-800-276-2206, www.bgmicro.com/ . They have/had a quantity of used A1's for $6.95. You may need to clean/straighten the pins, but so far the ones I bought work. Brett Anthony Research Technician School of Engineering and Computer (...) (29 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: 68HC811E2 Can't be set
|
|
I had the same problem with an A1, in this case it was stuck at 0x0D. hbdl would NOT set the config, but I was able to do it with dl from Win95 run in full MS-DOS mode. Even this was problematical; dl would invariably hang the computer once or (...) (29 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
|