 | | Re: Use built-in Ir instead of IR-Tower?
|
|
(...) The IR protocol is slightly different. While IRDA only sends short pulses the Lego Tower sends a signal for the whole time slot. It is very unlikely that one can get them work together. Jochen (23 years ago, 30-Sep-02, to lugnet.robotics.rcx.legos)
|
| |
| | Spybot to rcx and rcx to spybot
|
|
Hello I am just starting with my first Spybot and want to know how can I use a Spybot to controll an rcx and even better how can I control an spybot with the rcx. I know this has been discussed al lot here but its nearly impossible to filter all (...) (23 years ago, 30-Sep-02, to lugnet.robotics.spybotics)
|
| |
| | How to find maximum available memory for datalog, power consumption and sensor wire length?
|
|
Hi there, I'm preparing to write a log program to store temperature values in the datalog. After some experimenting and familiarizing with the datalog associated functions I've found the following: Using CreateDatalog(x) with x being a constant and (...) (23 years ago, 30-Sep-02, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: 2 rcx's
|
|
What about hooking a sensor port to a sensor port on another RCX? The sensor ports do output power for active sensors, so I imagine this could be detected by the other RCX. I'm just wondering if this would let you set up bi-directional (...) (23 years ago, 29-Sep-02, to lugnet.robotics)
|
| |
| | Re: 2 rcx's
|
|
Scott: (...) Yes it has been done. I used this set up to communicate between 2 RCX in a contest where I new many people would use IR and the room would be flooded with the stuff. The original message is here: (...) What I did was just put a lego (...) (23 years ago, 29-Sep-02, to lugnet.robotics)
|
