 | | Setting LNP host address
|
|
I've experimented with a couple of choices which were relatively easy to implement. Let me know if we should keep any these: 1. You can choose to set the host address at build time with a command-line option to make. Example: make LNP_HOSTADDR=2 (...) (24 years ago, 20-May-02, to lugnet.robotics.rcx.legos)
|
| |
 | | main() not defined?
|
|
I get this error - "main() not defined" - when compiling. The code is copied straight from the Ferrari book. While C is the language of my choice, the line of code isn't so obtuse as to hide errors from me. So probably there is some other requisite (...) (24 years ago, 20-May-02, to lugnet.robotics.rcx.nqc)
|
| |
 | | Re: remote control
|
|
The buttons "1", "2" & "3" send a IR message to the RCX. The RCX must be running a program that will respond to one or more of those messages. The A, B, C buttons will activate the RCX outputs forward or reverse. This requires only the installed (...) (24 years ago, 20-May-02, to lugnet.robotics)
|
| |
 | | Re: Powering motors from the mains
|
|
(...) One other thought here (and I'm not sure how "good" it is for the motors and I know that efficiency is not the best) is that you will note if you connect two motors together with the typical electrical connection wire (with no RCX in the (...) (24 years ago, 20-May-02, to lugnet.technic, lugnet.robotics)
|
| |
 | | lnpd and mandrake 8.2
|
|
Hi, I have install the last legOS and have install lnpd to. But i have a problem when i run an applcation lnptest for example : it don't work.... Here is the problem "lnp_init: Network is unreachable". I run lnpd with the command "lnpd --nolock (...) (24 years ago, 20-May-02, to lugnet.robotics)
|