 | | main() not defined?
|
|
I get this error - "main() not defined" - when compiling. The code is copied straight from the Ferrari book. While C is the language of my choice, the line of code isn't so obtuse as to hide errors from me. So probably there is some other requisite (...) (23 years ago, 20-May-02, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: remote control
|
|
The buttons "1", "2" & "3" send a IR message to the RCX. The RCX must be running a program that will respond to one or more of those messages. The A, B, C buttons will activate the RCX outputs forward or reverse. This requires only the installed (...) (23 years ago, 20-May-02, to lugnet.robotics)
|
| |
| | Re: Powering motors from the mains
|
|
(...) One other thought here (and I'm not sure how "good" it is for the motors and I know that efficiency is not the best) is that you will note if you connect two motors together with the typical electrical connection wire (with no RCX in the (...) (23 years ago, 20-May-02, to lugnet.technic, lugnet.robotics)
|
| |
| | lnpd and mandrake 8.2
|
|
Hi, I have install the last legOS and have install lnpd to. But i have a problem when i run an applcation lnptest for example : it don't work.... Here is the problem "lnp_init: Network is unreachable". I run lnpd with the command "lnpd --nolock (...) (23 years ago, 20-May-02, to lugnet.robotics)
|
| |
| | Re: NQC "No reply from RCX" Help Please
|
|
(...) I'm about to go ahead and wipe the laptop hard drive and just reinstall WinXP and see if I can get everything working from a clean install. I've done a LOT of things on this lap top and had quite a few USB devices installed... -Jeff McClain (23 years ago, 20-May-02, to lugnet.robotics)
|
