To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *32934 (-5)
  Re: General IR question
 
Typical remote control IRs like the RCX system are usually in the 870 - 950 nm range, just below visible red. A standard silicon CMOS camera chip will "see" this fine unless it has an IR cut filter (commonly installed in camcorders etc). Silicon is (...) (25 years ago, 14-May-02, to lugnet.robotics)
 
  Freebsd 4.4 and legos
 
Ok i just started using freebsd and i was wondering if anyone could tell me what tools i need to install to make legos compile and run correctly. Thankx, Jason Hensler (25 years ago, 14-May-02, to lugnet.robotics.rcx.legos)
 
  Re: More problems with floats
 
(...) It turns out to be the egcs 1.1.2 I compiled; the RPMs from sourceforge work fine. I'll try to find why my compiler was buggy... Thanks for your reply. Eric (25 years ago, 13-May-02, to lugnet.robotics.rcx.legos)
 
  General IR question
 
In general, what's the difference between the IR "signal" that the tower and RCX use to communicate and the IR energy used in thermal imaging? Is it just a matter of frequency? If the RCX was pointed at an IR camera, what what would it see? -- Dan (...) (25 years ago, 13-May-02, to lugnet.robotics)
 
  Re: Infrared communication expansion?
 
2 ways that have worked for me, both using the long range IR mode: 1) Point the RCX's IR Port at the ceiling and your IR Transmitter/ reciever unit at the ceiling and bounce the signals off your ceiling. I have vaulted ceilings painted white and get (...) (25 years ago, 13-May-02, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR