 | | 68HC11 modes
|
|
Return-Path: <roneill> Received: by thorung.eeng.dcu.ie (Linux Smail3.1.28.1 #5) id m0y2kzc-000FSwC; Wed, 11 Feb 98 22:51 GMT Message-Id: <m0y2kzc-000FSwC@tho...ng.dcu.ie> Date: Wed, 11 Feb 98 22:51 GMT From: roneill ("Richard O'Neill (...) (29 years ago, 12-Feb-98, to lugnet.robotics.handyboard)
|
| |
 | | a scary story
|
|
Just an interesting (or perhaps not) story about what just happened to me this week while putting my Handy-Board together. I was on the section where you put on the digital input circuitry, and all was going well so far - it loads pcode_hb.s19, (...) (29 years ago, 12-Feb-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Sonar
|
|
Yup. I loaded the sonar.c file and ran the sonar_display() routine. It just displays values that make no sense. The sonar doesn't click and the diodes get hot. After recieveing some mail from other, I have come to the conclusion that the diodes are (...) (29 years ago, 13-Feb-98, to lugnet.robotics.handyboard)
|
| |
 | | encoders
|
|
Hello all, I am attempting to use the shaft encoder routines but am having trouble.When I try to load the file fencoder0.icb I get a message that ic cannot find the file.Any hints? Also I would like to know whether these routines count off one edge (...) (29 years ago, 13-Feb-98, to lugnet.robotics.handyboard)
|
| |
 | | Interrupt for serial data
|
|
I've decided to write an interrupt routine for the handling of serial data on the Handy Board. An example of an interrupt routine is given in the Handy Board technical reference. This works like a charm. I've modified it to use the SCI interrupt. (...) (29 years ago, 13-Feb-98, to lugnet.robotics.handyboard)
|