 | | RFC: smaller task scheduler
|
|
I have been working on some changes to the task scheduler (and therefore execi, kill, killall) and have reduced the size/complexity a bit. I think it is ready for use (although I am going to continue to test it). Here is a bit of info. about it: (...) (23 years ago, 25-Mar-02, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Proposals, Bug Fixes, etc and tracking them with SourceForge
|
|
"Stephen M Moraco" <stephen_moraco@agilent.com> wrote in message news:GtIG2u.7Gy@lugnet.com... (...) I believe the firmdl application could load the .srec, look for a tag and replace the tag with the user selected RCX ID. Then transmit as it always (...) (23 years ago, 25-Mar-02, to lugnet.robotics.rcx.legos)
|
| |
| | Re: is it possible to use a polarity switch with a RCX input?
|
|
(...) Use a resistor to make one of the states of the switch read less than a full short. Setup as a light sensor. 0 means off 50~ means one state and 100 means another. This is the basis for alot of the touch sensor multipliers. I am sure if you (...) (23 years ago, 25-Mar-02, to lugnet.robotics, lugnet.robotics.rcx)
|
| |
| | Re: Rubber belts modelling
|
|
I just uploaded a Rubber Belt Generator utility, that creates DAT files for rubber belts taut between two pulleys. The rubber belt generated can have a square section or a round one, using cylinder primitive. This utility is available from (URL) (...) (23 years ago, 25-Mar-02, to lugnet.cad.dat.parts, lugnet.robotics, lugnet.technic)
|
| |
| | Robolab with non-LEGO cameras
|
|
Hi Robolab 2.5 specialists, Does anyone know how to configure the Robolab 2.5 multimedia settings to work with one of the following web-cameras: Omnivision 511 (FCC H52PT-6007) or Aiptek (Model AVS100A Art. 12047) Claude Baumann (23 years ago, 25-Mar-02, to lugnet.robotics)
|
