To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3201 (+5)
  6.270 ROBOT COMPETITION
 
FF> If you're making a family outing of it, my advice is to show up no FF> later than 4:30, drop the advance party off at the Mass Ave entrance FF> to get in and hold seats, and then have the remaining party park the FF> car and show up with pizza (...) (29 years ago, 3-Feb-98, to lugnet.robotics.handyboard)
 
  re: pcode that works without LCD
 
For the freeware IC, see (URL) Fred (29 years ago, 3-Feb-98, to lugnet.robotics.handyboard)
 
  68hc811e2 config reg.
 
My handyboard works great,with a 68HC11A1 mcu. The config of the 103f register was done in one try and had no problems. I then installed a 68HC811E2 MCU, (a 2k EEPROM version of the original). Using DLM, HBDL and PCbug to try set the config register (...) (29 years ago, 4-Feb-98, to lugnet.robotics.handyboard)
 
  Connecting a second sonar module
 
I'm curious about connecting two of the Polaroid sonar modules to the Handy Board v1.2. Does anyone know whether ports PD2, PD3 and TIC2 can be used to hook up the second unit in the same way that PD4, PD5 and TIC3 are used for one unit? Or is there (...) (29 years ago, 4-Feb-98, to lugnet.robotics.handyboard)
 
  9600 Baud
 
I'm sure that this has been posted tons of times, but I am trying to use the 9600 serial library. I can't seem to get anything to echo on Zterm. I used a phone cable and hooked it up to digital port 9, and then to the HB serial/charger. I get (...) (29 years ago, 4-Feb-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR