 | | Re: [Q] power supply for polaroid sonar
|
|
I haven't seen the schematic you're refering to but I believe you can use the +5V bus already on a standard HB. Just connect your PWR/GND to one of those headers "below" one of the A/D inputs. I did this before and it worked. Apparrently, the 1A +5V (...) (29 years ago, 19-Jan-98, to lugnet.robotics.handyboard)
|
| |
 | | Stepper motor
|
|
Hi, I trying to make a home page about interfacing handy board with stepper motors, I hope it has enought quality to add a little contibution to the handyboard effort. For now I has just two part : One is just mails I found in the mail archive about (...) (29 years ago, 20-Jan-98, to lugnet.robotics.handyboard)
|
| |
 | | New S19 with includes PWM routines for IC3.1?
|
|
Has anyone already created new a s19 file for IC3.1 than includes the new PWM routines? Jun Nolasco nolasco@inx.net (29 years ago, 20-Jan-98, to lugnet.robotics.handyboard)
|
| |
 | | Dead Board
|
|
We seem to have a problem and we're not sure how it came about, and even less sure about how to fix it. We were using our board to drive our robot. At this point we had a simple program, both motors on full forever. We turned the board on, the (...) (29 years ago, 20-Jan-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: New S19 with includes PWM routines for IC3.1?
|
|
I started on putting in the new PWM routines, but I don't expect to be able to finish until this weekend. - Mike (29 years ago, 20-Jan-98, to lugnet.robotics.handyboard)
|