To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3146 (+5)
  Re: Shaft Encoders
 
(...) Hi there, Would these chips be suitable for interfacing a mouse to the Handyboard? My robot incorporates a mouse as a castor wheel and I want to use its shaft encoders as position/velocity sensors (relative) for the robot, but I don't know (...) (29 years ago, 16-Jan-98, to lugnet.robotics.handyboard)
 
  Still problems to boot handyboard.
 
I still have problems with two handyboards. I can download the code but never boot my code (that code run in other handy, however) Other variant is if i put a 69hc11a1fn the handy download the initiatl bootstrap code , and when try to syncronize (...) (29 years ago, 17-Jan-98, to lugnet.robotics.handyboard)
 
  RE: M68HC711E9
 
O.K, , I still have a question. I'm working with a handy board and it use a special mode to talk to a LCD. If i understand , the handy board need to put the reset vector in the range BFC0 - BFFF. If get the aplication note for the 711E9 and ,as it (...) (29 years ago, 17-Jan-98, to lugnet.robotics.handyboard)
 
  pcode_hb.s19 downloading probs
 
hello, I tryed to download the pcode_hb.s19 file using DL, When it starts sending it stops and says "expected 244, received 150, after 144 chars recieved" I cant seem to get any of the downloaders to work. Im a bit stuck on where the problems lies (...) (29 years ago, 18-Jan-98, to lugnet.robotics.handyboard)
 
  Dallas NVRAM.
 
Well, finally i see the option of 711e9 is not god, i see the K9 version have 24 K optrom and the vector location is inside my optrom. That's god , because i need to start in special test mode. But , a little detail, in Argentina , where i'm live , (...) (29 years ago, 19-Jan-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR