To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3131 (+5)
  Motor Outputs
 
I built an H-Bridge over the weekend to replace the chips on the Handyboard and I was wondering what pins on the motor control sockets I need to connect the new circuit to? My circuit has a Forward input and a Reverse input. I did notice from the (...) (29 years ago, 12-Jan-98, to lugnet.robotics.handyboard)
 
  questions re: unix version of IC
 
Hi - I'm a handy-board/ic newbie, so please excuse this question if it's answers seem obvious. After two weeks of writing code in DOS/Windows (yuck), I downloaded the ic-2.860beta source code, which compiled without significant trouble in linux (...) (29 years ago, 13-Jan-98, to lugnet.robotics.handyboard)
 
  Re: questions re: unix version of IC
 
Joshua - There should be no problems using the Gleason Research libraries (or any of the libraries that are on the web site). There are no differences between version 2.851 and 2.860 from the point of view of the libraries. There is a pre-compiled (...) (29 years ago, 13-Jan-98, to lugnet.robotics.handyboard)
 
  E clock & R/W
 
Hi, I'd like to interface the HB to a HCTL1100. Does anyone already know could I pick the 68hc11 E clock and R/W pins??? Thx in advance Antony Vallee (29 years ago, 13-Jan-98, to lugnet.robotics.handyboard)
 
  Hb / Hctl1100 interface
 
Hello, does anyone know I could find the entire schematics about interfacing a HB with 2 Hctl1100 ??? It would be great!! Thanks in advance, Antony Vallee (29 years ago, 13-Jan-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR