 | | Re: send message from ir-tower to rcx
|
|
(...) I don't think you can with only Spirit.OCX. I think you need the capability of the new SDK. Have you been able to send bytecodes using Spirit, or are you using another tool? --Ian (24 years ago, 12-Jan-02, to lugnet.robotics)
|
| |
| | Re: Inertial guidance
|
|
(...) Actually, i think you could use TWO rotation sensors because the rotation sensors work in both directions, and Lego generally doesnt go up and down (but it might if you had some sort of maze with ramps). (24 years ago, 12-Jan-02, to lugnet.robotics)
|
| |
| | Re: Precise turns of any angle! -- Rotation Sensor Information
|
|
(...) I ran my rotation sensor in an experiment at nominal motor speeds of 300 rpm and didn't lose a single count in over 10 minutes of testing. I believe the 1250 RPM figure...although you may be right about it being worse with the RIS 2.0 (...) (24 years ago, 12-Jan-02, to lugnet.robotics)
|
| |
| | Re: Inertial guidance
|
|
(...) The term "inertial guidance" refers to a navigational technique that involves carefully measuring the rotational and translational accelleration of the vehicle, then integrating that to derive the velocity and integrating *that* to get the (...) (24 years ago, 12-Jan-02, to lugnet.robotics)
|
| |
| | Re: send message from ir-tower to rcx
|
|
My replacement for spirit.ocx does not yet support sending messages to the RCX, but it would only take 10 min to add it. (It is planned, but first I am working on cloning spirit.ocx). As for receiving, the IR tower shuts down to fast to reliably (...) (24 years ago, 12-Jan-02, to lugnet.robotics)
|
