To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *31 (+5)
  RE: Connected Radioshack truck
 
(...) You know what makes REALLY good REALLY cheap shaft encoders? Mice! Get an old mouse that has a broken button (that's usually what goes on mice) and pull it appart. Sometimes, depending upon the kind of mouse, you can get really luckey, and be (...) (31 years ago, 6-Feb-96, to lugnet.robotics.handyboard)
 
  battery voltages
 
Regarding the use of a 6V ni-cad pack to solve my over-voltage problem in driving small motors, could I still use my current 9.6V pack, but simply insert a tap into the battery at somewhere close to 6V? Seems nicer than buying another battery pack, (...) (31 years ago, 6-Feb-96, to lugnet.robotics.handyboard)
 
  Re: battery voltages
 
(...) Yes, and the current capacity would be the same, since excess voltage gets dissipated in the HB's voltage regulator. -Fred (31 years ago, 6-Feb-96, to lugnet.robotics.handyboard)
 
  Robot Chassis
 
Given the extensive traffic concerning robot platforms, I thought I'd add my two cents: For my senior project at Cal Poly I made a robot that had three wheels, two of which were independently driven and one which was a small caster. The chassis and (...) (31 years ago, 7-Feb-96, to lugnet.robotics.handyboard)
 
  Re: battery voltages
 
(...) I'd use 6V instead of the 9.6V main power supply - connect it where the main battery terminals are. It'd be really nice if the handy board had a way to use voltages other than 9.6V for the motor driver chips, ya know. :-) (31 years ago, 7-Feb-96, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR