 | | Re: Electro-magnets
|
|
Another simple source is a 12 volt electro-magnetic clutch. These are available on the surplus market, with typical price around $5 US. - pete. (...) (24 years ago, 12-Dec-01, to lugnet.robotics)
|
| |
| | Re: Mario's new book...
|
|
(...) A quick link to the publisher's site: (URL) (24 years ago, 12-Dec-01, to lugnet.robotics)
|
| |
| | Trigonometry and NQC
|
|
Hi! I'm working on a project where a robot needs to travel a right triangle with unkown side lengths. Basically, the robot starts at a point in a room, travels perpendicularly toward a wall, turns 90 degrees left when it hits, and when it gets to (...) (24 years ago, 12-Dec-01, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: Forced to use IR Tower?
|
|
(...) If I understand you correctly, you wish to use the IR port built into your laptop instead of the IR tower. To the best of my knowledge this is not possible. John Hansen (24 years ago, 12-Dec-01, to lugnet.robotics.rcx)
|
| |
| | Forced to use IR Tower?
|
|
Hi all, sorry if off-topic, but perhaps anybody knows if there is anyway to communicate with RCX through my laptop ir port. Actually I connect with my Palm through COM4, but when I set Bricxcc to this port says can't find robot. Thanks Francis (24 years ago, 12-Dec-01, to lugnet.robotics.rcx)
|
| |
| | Kill / reset / power switch for RCX
|
|
I manage to semi-regularly crash LegOS (usually thanks to wandering pointers) to the point where a firmware reload is required and the reset button combination doesn't respond. In order to save myself popping the batteries out every time, I decided (...) (24 years ago, 12-Dec-01, to lugnet.robotics)
|
| |
| | Re: Request for new P-code.s19
|
|
Dan, I am also interested in obtaining the different flavors of the p-code floating around on the net. In my case I would like to also get one for an 20x4 LCD screen size. If there are any sites with them available or ones that might have a (...) (24 years ago, 12-Dec-01, to lugnet.robotics.handyboard)
|
| |
| | Re: Electro-magnets
|
|
In message <145.625b6f1.2947e682@aol.com>, Styxrocks@aol.com writes (...) I was going to experiment with electromagnet cranes, like the ones you see at junk yards. I will try your suggestion (when I've finished my current project). I will also try (...) (24 years ago, 12-Dec-01, to lugnet.robotics)
|
| |
| | Re: marble rail
|
|
Nice job, Chris! much more impressive than my seesaw... ((URL) you coordinate marble position and rail movement? If so, how ? A video clip and DAT files would be very appreciated ;o) Philo (24 years ago, 12-Dec-01, to lugnet.robotics)
|
| |
| | Re: marble rail
|
|
oopse I forgot the link to the pictures (URL) (24 years ago, 12-Dec-01, to lugnet.robotics)
|
