 | | about peek() and poke()
|
|
Hello, I have some questions about serial communication of the HandyBoard to PC. I tried to write to the serial line from HB. But I found that peek() and poke() functions don't work. (I used "list functions" to list all the functions available, and (...) (25 years ago, 29-Nov-01, to lugnet.robotics.handyboard)
|
| |
 | | Re: Can I use LegOS with CyberMaster?
|
|
(...) That is not possible, the Cybermaster has the firmware in ROM and very little (a few hundred bytes) RAM. (...) It doesn't. (...) The only one is NQC. Jürgen (25 years ago, 29-Nov-01, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: COLOR light sensor
|
|
(...) (URL) Jürgen Stuber <stuber@loria.fr> (URL) (25 years ago, 29-Nov-01, to lugnet.robotics.rcx)
|
| |
 | | Re: Output to Display
|
|
Alan (...) LCD (...) Yup. In RL2.5 Investigator, select through the palettes as follows: Datalogging & motors > RCX Communications > Set Display. The 'Set Display' icon looks like the RCX's LCD panel. You need to hang two modifiers off it. On the (...) (25 years ago, 29-Nov-01, to lugnet.robotics.rcx.robolab)
|
| |
 | | Re: BricxCC release 3.3.2.12
|
|
(...) I guess I don't see so close a tie between the NQC code in a .NQC file and the brick type, port number, and program slot. A program running on RCX in slot 3 downloaded via COM4 could just as well run on an RCX2 in slot 1 downloaded via USB2. (...) (25 years ago, 29-Nov-01, to lugnet.robotics.rcx.nqc)
|