To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3036 (-5)
  Re: IC with other boards
 
(29 years ago, 2-Dec-97, to lugnet.robotics.handyboard)
 
  IC with other boards
 
Is is possible to run the freeware IC with the BotBoard II? (How?) Also, what is the difference between the RugWarrior version of IC and the Handyboard version? -- Justin Kao <jkao@bigfoot.com> <jkao@compuserve.com> (29 years ago, 1-Dec-97, to lugnet.robotics.handyboard)
 
  PCBs in the UK
 
Hello, This is a note for people in the UK. I just ordered 2 sets of handy board PCBs from Colin Barnard of Miranda Robotics. The boards arrived quickly and appear to be good quality boards. -Jeff Loeliger r12110@email.sps.mot.com (29 years ago, 1-Dec-97, to lugnet.robotics.handyboard)
 
  Re: IC problem
 
(...) Alright, I have isolated the problem a little more since last time. It turns out that when I put my finger over a certain area of the solder side of the board, I can run IC perfectly well. The area is right around pin 22, 21 and 20. I believe (...) (29 years ago, 1-Dec-97, to lugnet.robotics.handyboard)
 
  Re: Smoking serial/charger board...!!!
 
Hi. This evidence pretty conclusively points to a power-ground short on your board. Here is why: * you are fairly certain it is not the RJ11 cable (the most common cause of blown R11's). * when applying charge pwr directly to the HB's charge jack, (...) (29 years ago, 1-Dec-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR