 | | LCD Connector?
|
|
Hello to ALL, I was wondering if the LCD connector could be used to connect a speech board from RC Systems. Could I unplug the LCD module and use the plug ins for the board w/ an additional power source for the board? Thanks, Randy Eaton (...) (29 years ago, 28-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: Smoking serial/charger board...!!!
|
|
I am having a similar problem (see notes below) - R11 is burning on the serial/charger board. My HB had been on the shelf for a month or so, and it may have been left on AND I had made the motor-power hack (I tapped the center of the battery pack to (...) (29 years ago, 28-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | IC problem
|
|
Hi guys, I know that this exact question came up once before in this newsgroup, but its reply has long since gone to the bit bucket in the sky, so forgive me. Anyway, I can get the following message on my handy-board: Interactive C V 2.81 9/28/93 (...) (29 years ago, 29-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | Robotics club in the Los Angeles area.
|
|
Does anybody know of a club in the Greater LA area. The only one I've found so far is over an hours drive away. Any info would be helpful. Thanks Mike (29 years ago, 30-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: IC problem
|
|
(...) Hi Jeremy, My board does that sometimes too. Are you useing the same telephone cable? Make sure all other programs are closed on your computer. Reset the board by turning it off and then back on. Good luck Terry (29 years ago, 30-Nov-97, to lugnet.robotics.handyboard)
|