To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *29554 (-5)
  Re: Power inlet to RCX 1.5?
 
(...) Check out this site, Jürgen: (URL) least it used to be there... Grtz., Remko (25 years ago, 23-Aug-01, to lugnet.robotics)
 
  Re: Proper power supply for a 1.0?
 
(...) First off have you connected the right two plates? First, I'd suggest using a 9 volt battery to find the right two plates. The RCX has built in reversed polarity so with a 9volt battery you won't damage anything. THEN ONLY USE 9 volts (...) (25 years ago, 23-Aug-01, to lugnet.robotics.rcx)
 
  Re: bushing (bush) question
 
(...) They're pretty much the same. But I think Type 1 bushings often have a tighter fit than Type 2 bushings. It really depends on each specific part and its particular tolerances. I have some Type 1's that are extrememly tight fitting, and others (...) (25 years ago, 23-Aug-01, to lugnet.robotics, lugnet.technic)
 
  Re: bushing (bush) question
 
(...) I don't have any hard evidence, but I've always found that the type 2's (later version) grip a little more consistantly. The type 1's in my collection are either *really* tight or just moderately tight. Type 2's seem to be consistantly (...) (25 years ago, 23-Aug-01, to lugnet.robotics)
 
  Re: Migrating from IR tower/spirit.ocx to USB
 
Take a look at the code in (URL) some examples. -a "Dave Hallowell" <lego-robotics@crynwr.com> wrote in message news:NEBBLJAEMKLDMPB...ems.com... (...) (25 years ago, 23-Aug-01, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR