To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *29464 (-5)
  Re: Is Expansion Board Servo Voltage Suppose to Be 9v
 
Do you have the dropping 2n540x diodes in place? they should drop the 9.6v batt to the 5-6v servo voltage. Fred (...) (25 years ago, 15-Aug-01, to lugnet.robotics.handyboard)
 
  Is Expansion Board Servo Voltage Suppose to Be 9v
 
Hello again, I was surprised to find that my expansion board servo ports were putting 9 volts. Is this the way the board was designed or is this in error. Most servos I have come across work in the upper 4 to 6 volt range. The servo I have runs (...) (25 years ago, 15-Aug-01, to lugnet.robotics.handyboard)
 
  Help Needed With Serial Output Drivers Syntax
 
Does anyone have an example of how to use the 7i9600 serial driver with the Scott Edwards SSC II. I cannot seem to find any documentation. Thanks, Andy Loy andyl@citlink.net (25 years ago, 14-Aug-01, to lugnet.robotics.handyboard)
 
  Dos VLL Interpreter / Driver
 
Hi all; I have developed a DOS VLL Interpreter / Driver that does not use the Scout to talk to the MicroScout, rather it uses a simple LED driver circuit direct attached to the PC Parallel port. There are two versions; both DOS based. One is a (...) (25 years ago, 14-Aug-01, to lugnet.robotics.vll)
 
  Report from RoboCup 2001
 
RoboCup 2001 Seattle, WA August 2-10 2001 Same story, multiple URLs: (URL) site: (URL) (25 years ago, 14-Aug-01, to lugnet.mediawatch, lugnet.robotics.events)  

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR