To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *29389 (-5)
  Re: SetWatch() only accepts constants
 
(...) You can use the NQC -watch now command to set the time. Dean (25 years ago, 7-Aug-01, to lugnet.robotics.rcx.nqc)
 
  Help needed for an NQC newbie
 
Hi, Normally you can see me in .space, .loc.ca, or org.ca and the like. But now that I have an RCX I want to program a bit. I have written my first NQC program and compiled it using RCXCC. I then downloaded it to my RCX but when I press run the legs (...) (25 years ago, 7-Aug-01, to lugnet.robotics.rcx.nqc)
 
  Re: How can I build sensor to measure eeg
 
(...) Try searches for "instrumentation amplifier schematic". Everything must be battery-powered, as you have to break down the skin's electrical resistance with things such as KY jelly or salts-based electroconductive gel (very irritating to the (...) (25 years ago, 7-Aug-01, to lugnet.robotics)
 
  Re: transfer data failed
 
(...) I am using 0.2.4 under windoz and have had similar problems. I found that I must use the slow download option (-s) for the firmware to load properly. regards (25 years ago, 7-Aug-01, to lugnet.robotics.rcx.legos)
 
  RE: SetWatch() is remembered?
 
Take the batteries out (and unplug the external power on RIS 1.0) and it forgets everything, Date, Time, Programs/Tasks, even "Firmware"... "ZZZzzzombie" RCX :) mc. (...) (25 years ago, 7-Aug-01, to lugnet.robotics.rcx.nqc)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR