To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *29239 (-5)
  LMD18200
 
Hi, I have a question about the PCB that Matt Harlan have made for an LMD18200 H-Bridge. In that PCB seems that the Thermal Flag Output of the chip goes directly out and ready to connet to the HB, but this output will not be, in the case of set, of (...) (25 years ago, 27-Jul-01, to lugnet.robotics.handyboard)
 
  RE: Power inlet to RCX 1.5?
 
(...) There are 12 contact pads in the battery bay. One is the + lead to the RCX, one is the - lead to the RCX, and the other 10 are used to connect the batteries in series. You need to supply power to the two contact pads that connect to the RCX (...) (25 years ago, 27-Jul-01, to lugnet.robotics)
 
  Re: A review of 8539 (Manas)
 
Hi, John You can use SetSerialComm(SERIAL_COMM_4800) for RCX2, check NQC Guide. Zhengrong (...) RCX (...) knows (...) (25 years ago, 27-Jul-01, to lugnet.robotics)
 
  Re: Power inlet to RCX 1.5?
 
(...) That's right, Darren, but I'm not from Britain, so I'll look at the product for ideas. Is it necessary to fill the entire battery bay, or will one AA suffice to provide the power needed? Also, I'm not only pondering the technicalities of (...) (25 years ago, 27-Jul-01, to lugnet.robotics)
 
  Re: A review of 8539 (Manas)
 
In lugnet.robotics, Hao-yang Wang writes: <snip> (...) Well, duh! It's Lego(r) and it's Remote Control. Of course John Barnes sussed it. My question is what took him so *long*?? :-) (25 years ago, 26-Jul-01, to lugnet.robotics, lugnet.technic)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR