To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *28819 (-5)
  Phasing Errors and as11
 
Has anyone managed to sort out all the "phasing errors" you get when you try to reassemble pcode v3.1 using as11? Thanks, George Musser georgejr@musser.com (25 years ago, 13-Jun-01, to lugnet.robotics.handyboard)
 
  How many 5 wire steppers?
 
I have a Handyboard with the expansion board. I'm building an interactive sculpture with the board. This is my first use of my Handyboard. I would like to hook up five or six stepper motors to the board. The motors I'm using are scrapped from old (...) (25 years ago, 13-Jun-01, to lugnet.robotics.handyboard)
 
  Re: Beginners Quest.
 
The E1 chip works with the Handy Board. Actually, any of the 52-pin PLCC 6811s will work. You may have to change the CONFIG register to get Interactive C to run. Fred (...) (25 years ago, 13-Jun-01, to lugnet.robotics.handyboard)
 
  Squeak for RCX
 
Has anyone considered using Squeak to build a graphical RCX programmer app? (URL) wondering if it's possible and am not much of a programmer myself. -Suz (25 years ago, 13-Jun-01, to lugnet.robotics.edu, lugnet.robotics.rcx)
 
  Pyro sensor
 
Hi! Does anyone has implemented a person following behavior? If so I would appreciate any hardware or software details. If I'm not wrong, I can modify one of those PIR detectors used with burglar alarms as it has the sensing element and amplifiers (...) (25 years ago, 13-Jun-01, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR