 | | 68HC11's inputs
|
|
John, Thanks for the excerpt. Ouch. On first read, it looked like the 6811's input pin was beefier than I had originally thought. On my second reading, I realized that my hack probably is in fact outside the specs for the chip, so if you're trying (...) (29 years ago, 27-Aug-97, to lugnet.robotics.handyboard)
|
| |
 | | Help!!!! Handy Board Problem
|
|
Hi! I'm currently assembling the handy board, and i got to the stage where i have the bare minimum to run IC. The problem starts when I try to send commands from IC (ver 2.851) to the handy board (running v 2.81). About 85% of the time i get the (...) (29 years ago, 27-Aug-97, to lugnet.robotics.handyboard)
|
| |
 | | Manipulate the LCD in assembler
|
|
I have write a code for manipulate the LCD in the handy board. Because i can't use a battery backed RAM, i need to write in assembler. Well , i'm really read all the FAQ for LCD and for Handy board (including the apendix B for the 6270) .I'm using (...) (29 years ago, 27-Aug-97, to lugnet.robotics.handyboard)
|
| |
 | | microphone as a sound sensor?
|
|
Hi all, has anyone interfaced a microphone to an analog input of the HB? I've amplified the signal with an op-amp (LM386) but can't figure how to integrate the (AC) signal into a usable voltage range for the HB. I don't think that just rectifying (...) (29 years ago, 27-Aug-97, to lugnet.robotics.handyboard)
|
| |
 | | Microphone on a Handyboard
|
|
(...) Assuming you've hooked the LM386's ground to ground and the + voltage to 5v, you should be set hooking the output of the LM386 to the analog input. Do not insert a capacitor in series, as might be shown for hooking up the LM386 to a speaker. (...) (29 years ago, 27-Aug-97, to lugnet.robotics.handyboard)
|