To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *2651 (+5)
  digital ins
 
Hi all, At what voltage on the digital ins does one risk damaging the HB? I want to feed an amplified signal to the digital ins on my HB to exaggerate the response of a photosensor in the 2-3V range of its operation. Unfortunately, this means that (...) (29 years ago, 26-Aug-97, to lugnet.robotics.handyboard)
 
  Adding to the data bus
 
After looking at the addressing scheme on the handyboard and determining it is possible to add a number of more outputs and inputs by extending the data lines to another board and using the free lines comming from the 74hc138. I built a robot arm (...) (29 years ago, 26-Aug-97, to lugnet.robotics.handyboard)
 
  Re: digital ins
 
(...) 5.12 volts (...) Yes. (...) 5.12 volts max, 0 volts minimum (...) The correct solution to your problem is to use an op-amp signal conditioner, possibly feeding into a schmidt trigger if you need some hysteresis. (sp?) You can also rig a zener (...) (29 years ago, 26-Aug-97, to lugnet.robotics.handyboard)
 
  Re: digital ins
 
(...) ... (...) Chuck is right about the correct solutions. For a less correct solution, you can take advantage of the fact that HC parts (including the 6811) have built in voltage limiters that are only good for fractional milliamps (in some cases (...) (29 years ago, 26-Aug-97, to lugnet.robotics.handyboard)
 
  Re: digital ins
 
(...) From the pink book (rev 3): pp. 2-24,25 "2.4.3 Internal Circuitry - Digital Input-Only Pin ...When the pin current is increased to very high levels (typically more than 100mA, specified limit is 25mA), physical damage can result. [...] As (...) (29 years ago, 26-Aug-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR