To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *26184 (-5)
  Re: IR Tower problems
 
(...) Eep!!! Not PRINTER port but the SERIAL port. You'll damage your Port and maybe the IR tower as well! Try it in the SERIAL port and it will work much better. Dean -- Coin-Op's For Sale!: (URL) Lego Workshop: (URL) Lego Club: (URL) (26 years ago, 21-Jan-01, to lugnet.robotics)
 
  Re: Anyone made animatronics with the RCX yet?
 
(...) I tried to have my Raptor puppet set up with Pneumatics but I gave up because I couldn't find a decent way of triggering it. The ways I had it were way to slow and painful. Has anyone come up with a great way of using pneumatics with (...) (26 years ago, 21-Jan-01, to lugnet.robotics.rcx)
 
  IR Tower problems
 
I recently purchased an IR tower to use with my Scout. It did not come with a cable, but the tower was only 6$(www.eblok.com), so I found a cable that could plug into the back of it. The other end of the cable fit into the printer plug on the back (...) (26 years ago, 21-Jan-01, to lugnet.robotics)
 
  Re: LegOS 0.2.5 and LNP
 
(...) Ok. Checking and testing never hurts :-). (...) It's not for performance, but for correctness. The old code was like this: if(lnp_addressing_ha...ler[port]) { ... lnp_addressing_handl...th-2,src); You first test lnp_integrity_handler and then, (...) (26 years ago, 21-Jan-01, to lugnet.robotics.rcx.legos)
 
  Re: LegOS 0.2.5 and LNP
 
(...) you may see (...) give access (...) the handlers (...) My only (...) depend on. (...) introduce a (...) this point to (...) I think that we can use safely (CONF_TM || defined CONF_HOST) condition. I'm checking the whole patch and I think that (...) (26 years ago, 21-Jan-01, to lugnet.robotics.rcx.legos)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR