 | | Re: 3v motors
|
| Yeah, you're right. I hadn't realize that constraint of the L293's. Sorry :b ---...--- ericson mar Master of Engineering Candidate Project: Mobile Robotics mar@cooper.edu (212)353-4356 Department of Mechanical Engineering The Cooper Union for the (...) (29 years ago, 9-Aug-97, to lugnet.robotics.handyboard)
| | |  | | Re: Voltage
|
| Yeah, the 12V goes into the motor power pin of the L293's. Thus you will get a higher than 9.6 motor voltage. ---...--- ericson mar Master of Engineering Candidate Project: Mobile Robotics mar@cooper.edu (212)353-4356 Department of Mechanical (...) (29 years ago, 9-Aug-97, to lugnet.robotics.handyboard)
| | |  | | positioning of robot
|
| Hello, First my apolgies for my bad english (my dutch is mutch better but afcouse thats becoust dutch is my first language). anyway. im working on a robot and use lego to test the best way for moving a robot. i see 3 options.. 2 weels, 4 weels (like (...) (29 years ago, 10-Aug-97, to lugnet.robotics.handyboard)
| | |  | | re: magnetic card readers
|
| dear german, i think what's going on is that you are asking very open-ended questions that require a lot of work to compose a helpful response. if i remember right, your earlier question was with regard to networking using the spi port of long (...) (29 years ago, 10-Aug-97, to lugnet.robotics.handyboard)
| | |  | | More juice
|
| Can you parallel a 9.6v eight pack NiCad cell to the HB Nicad pack? Has anyone done this with success? If so, does it charge properly? jm (...) (29 years ago, 11-Aug-97, to lugnet.robotics.handyboard)
| |