 | | Re: For you German speakers
|
|
Go to (URL) the option to translate a web page from German to English. Copy in the URL and hit the button. Voila! You get the page translated into (rather comical and error-filled) English. Its good enough to understand. I hope that helps! Brad (...) (26 years ago, 7-Dec-00, to lugnet.robotics)
|
| |
 | | Re: For you German speakers
|
|
Hi, Jonathan It may be asking too much, but is there an english version? It seens very interesting but my german knowledge is too basic... Maybe that would be a good reason to continue learning. :) cya, Mauro Jonathan Knudsen (...) (26 years ago, 7-Dec-00, to lugnet.robotics)
|
| |
 | | Re: Using Vision Command as a Smart Sensor
|
|
(...) Nice page. It's such a shame that LEGO didn't think to just allow a person to use the MSG's when a zone is active... That's one huge oversight... Dean -- Coin-Op's For Sale!: (URL) Lego Workshop: (URL) Lego Club: (URL) (26 years ago, 7-Dec-00, to lugnet.robotics, lugnet.robotics.vc)
|
| |
 | | Re: Using Vision Command as a Smart Sensor
|
|
Rainer Balzerowski <balze2@gmx.net> wrote in message news:G55w18.1Ip@lugnet.com... (...) It does slow down VC a little to leave the 1.0 seconds in the Spin Left. You really notice it if you put long numbers like 100 seconds in. I've incorporated (...) (26 years ago, 7-Dec-00, to lugnet.robotics, lugnet.robotics.vc)
|
| |
 | | Re: Sharp GP2D12 and Expansion Board
|
|
I tried replacing the MUX...that wasn't it. I just noticed that I can read analog(19) through analog(16) but I can't read analog(19) directly...must be an address problem....the question is where. "Robin Chahal" <rchahal@hotmail.com> wrote in (...) (26 years ago, 7-Dec-00, to lugnet.robotics.handyboard)
|