 | | Geting Started?
|
|
Hi everyone, I am fairly new to robotics/electronics and was wondering how to get started with the HandyBoard. So what is the best way to get started? I already know how to program more or less in C and a little in C++ can you program the Handy (...) (29 years ago, 21-Jul-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: LM34 temp sensor to handy board?
|
|
It sounds like you just want a standard non-inverting amplifier. wire an op amp like this: |\ sensor------|+\ | >-+-analog input of 6811 +--|-/ | | |/ | +----R1-+ | R 2 | GND where R1 and R2 are chosen such that (R1+R2)/R2 is the gain you want, in (...) (29 years ago, 21-Jul-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: Geting Started?
|
|
Why don't you start by perusing the web site... pretty much all of your questions are answered there. The site's home URL is (URL) in particular: * the FAQ * the "get your hands on a handy board" * the software resources page * the tech docs page (...) (29 years ago, 21-Jul-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: LM34 temp sensor to handy board?
|
|
I tried the circuit out tonight, and it works! (Mostly.) I hooked up a 1K and a 3K resistor for R2 and R1, for a gain of 4, and the output is roughly linear with the input. Still need to do some more testing. I ended up having to use a +/- 12V (...) (29 years ago, 21-Jul-97, to lugnet.robotics.handyboard)
|
| |
 | | Serial Communications.
|
|
I am considering using two MiniSSC II servo controllers from Lynxmotion ((URL) to control the servos on a six leg walker using the handyboard as the CPU. The only problem is that the MiniSSC uses asynchronous serial communication. Is it possible to (...) (29 years ago, 21-Jul-97, to lugnet.robotics.handyboard)
|