 | | Re: Chip Puller
|
| R> Does anyone know where I can buy a chip puller for the 6811. R> Robin Jameco sells 'em ((URL) Part no 16766 $3.95 If you are careful, and stuff, you can use little screwdrivers to pull chips. Wiggle one corner loose, then the other, then the (...) (29 years ago, 3-Jul-97, to lugnet.robotics.handyboard)
| | |  | | Chip Puller
|
| Does anyone know where I can buy a chip puller for the 6811. Robin (29 years ago, 3-Jul-97, to lugnet.robotics.handyboard)
| | |  | | Re: voice synthesis
|
| (...) Wow, impressive board. However, it's a bit out of my price range - I was hoping for a solution just about as cheap as the Radio Shack one used to be. Quality of speech isn't that much of a factor, I'm merely going to try and put this thing on (...) (29 years ago, 3-Jul-97, to lugnet.robotics.handyboard)
| | |  | | Svar: Trouble shooting 7.2.2 (The digital inputs)
|
| Hej I'm had the same problem, until i found that I loaded some programs via lib-file, not suitably for HB. (lib_r22.c) It seems you are running some programs for the 6.270. Have You setup IC correct? Try run c:\IC -config. Check out your lib-files. (...) (29 years ago, 3-Jul-97, to lugnet.robotics.handyboard)
| | |  | | Re: Future versions of handyboard?
|
| (...) I suspect there probably aren't such plans. One of the problems is the amount of infra-structure needed for a successful board. Basically you need a good board and a good development environment, and you have to be as inexpensive as possible (...) (29 years ago, 3-Jul-97, to lugnet.robotics.handyboard)
| |