To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *2406 (+5)
  lcd and ds1233-10 supplier
 
Just for the record, I was able to get the Hitachi LCD and the Dallas Semi. voltage monitor from Sterling Electronics. Their number is (512)836-1341. This location is in Austin, TX, but I think that they have a 1800 number, though I don't know it. (...) (29 years ago, 3-Jul-97, to lugnet.robotics.handyboard)
 
  Re: Future versions of handyboard?
 
(...) I suspect there probably aren't such plans. One of the problems is the amount of infra-structure needed for a successful board. Basically you need a good board and a good development environment, and you have to be as inexpensive as possible (...) (29 years ago, 3-Jul-97, to lugnet.robotics.handyboard)
 
  Svar: Trouble shooting 7.2.2 (The digital inputs)
 
Hej I'm had the same problem, until i found that I loaded some programs via lib-file, not suitably for HB. (lib_r22.c) It seems you are running some programs for the 6.270. Have You setup IC correct? Try run c:\IC -config. Check out your lib-files. (...) (29 years ago, 3-Jul-97, to lugnet.robotics.handyboard)
 
  Re: voice synthesis
 
(...) Wow, impressive board. However, it's a bit out of my price range - I was hoping for a solution just about as cheap as the Radio Shack one used to be. Quality of speech isn't that much of a factor, I'm merely going to try and put this thing on (...) (29 years ago, 3-Jul-97, to lugnet.robotics.handyboard)
 
  Chip Puller
 
Does anyone know where I can buy a chip puller for the 6811. Robin (29 years ago, 3-Jul-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR