 | | Freeware ICC11 and bad iasm11.exe?
|
| Me again, I just got the ICC11 freeware from the Miniboard site and installed it, moving the crt.s over as it says to do in the docs, etc. I tried to compile the test compile of icc11 dhry.c printf.c and got a LOT of "phasing" errors, whatever that (...) (26 years ago, 5-Oct-00, to lugnet.robotics.handyboard)
| | |  | | Miniboard download random failures
|
| Hello, I just finished building a Miniboard using the HC811E2 processor. After swapping the Rx and Tx lines on my serial cable the download and reset switch do as the manual says. However, when I use dlm to download a program the bootstrap section (...) (26 years ago, 5-Oct-00, to lugnet.robotics.handyboard)
| | |  | | Cybermaster on sale
|
| Yesterday I saw that the Cybermaster is on sale at the Bart Smit toy shops in the Netherlands, now only fl. 169,- (approx US$ 70) instead of fl. 449,-. I bought just one... Emile. (26 years ago, 5-Oct-00, to lugnet.robotics)
| | |  | | Re: The datalog
|
| (...) Series of measurements. I've used it to measure light sensor values while doing a 360 degree turn next to a candle (disappointing, the candle made hardly a dent), and to measure raw values for touch sensors while pushing them slowly, 1/100mm (...) (26 years ago, 5-Oct-00, to lugnet.robotics.rcx.nqc)
| | |  | | Re: Remote dead, what to do?
|
| (...) Are you sure it is the remote? Maybe your RCX forgot its firmware, then the remote won't work. Jürgen (26 years ago, 5-Oct-00, to lugnet.robotics)
| |