 | | Linux and v1.21 handyboard (fwd)
|
|
Hi, I've successfully located and compiled the IC files for the Handy Board. I can load and run programs on the board, BUT the digital input(s) are not being "seen". E.g. a simple program like: void test3(){ while (1){ if (digital(10)) printf("10 is (...) (26 years ago, 5-Oct-00, to lugnet.robotics.handyboard)
|
| |
 | | Re: The datalog
|
|
(...) numbers. It can only log timers, sensors, variables, and the system watch. When a value is logged, its source is also logged. For example, AddToDatalog(Timer(1)) adds the current value of Timer 1 to the log and also stores that this entry came (...) (26 years ago, 5-Oct-00, to lugnet.robotics.rcx.nqc)
|
| |
 | | communication via serial port
|
|
Hi, This isn't an off topic question... Has anyone tried programming the serial port (on Linux) to communicate with the Handyboard? I am working on an RF link between the Handyboard and a PC via serial communication, but I don't know much about (...) (26 years ago, 5-Oct-00, to lugnet.robotics.handyboard)
|
| |
 | | Re: external power
|
|
I am by no means an expert on the subject but this is how I did it. First I cut the heavy motor power trace as shown in the FAQ. Next I soldered a four pin female header on top of the expansion board where the expansion board picks up power for the (...) (26 years ago, 4-Oct-00, to lugnet.robotics.handyboard)
|
| |
 | | Re: A neat idea for touch sensors
|
|
(...) Those resistors in the Cybermaster touch sensors are in parallel to the sensor. You can read its value when the sensor is not pressed. Cybermaster uses it to figure out which sensor is connected to what port before starting the actual program. (...) (26 years ago, 4-Oct-00, to lugnet.robotics)
|