To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *23979 (-5)
  Re: IRPD sensors and LegOS (long)
 
OK, the IRPD rover just smarter. I had an error in the comments in the previously posted version, references in the initial comments about the Right Side Motor being hooked up to Output B were incorrect, it is actually hooked up to Output C. This (...) (26 years ago, 4-Oct-00, to lugnet.robotics.rcx.legos)
 
  Re: Roving Webcam Robot
 
Here is a shot through the robot's camera. I just added a Lego gauge. The little gauge is fun, but it times out to sleep. It has a lot of functions... a few more might be fun. (URL) (26 years ago, 4-Oct-00, to lugnet.robotics)
 
  Re: A neat idea for touch sensors
 
That is a neat idea! (...) (26 years ago, 4-Oct-00, to lugnet.robotics)
 
  Re: Dave Baum's scanbot w/ bumper?
 
(...) The problem is subtle. Scanbot (at least scanbot2.nqc) assumes that the drive motors are always running. It only alters their direction during steering. In your code you call OnFor(), which turns on the motors, waits a specified amount of (...) (26 years ago, 4-Oct-00, to lugnet.robotics.rcx)
 
  Re: The datalog
 
(...) Each call to AddToDatalog() uses up one "point". Each point takes up 3 bytes of memory: a 1-byte code for the source of point (sensor, timer, etc), then a 2-byte value. 123456 is too big to fit into the log. This would either generate a (...) (26 years ago, 4-Oct-00, to lugnet.robotics.rcx.nqc)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR