To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *23739 (-5)
  Re: Advice on Rotation sensors and steering please.
 
Of course, for the back wheels you could join the two shafts in a differential and the difference of the two would appear in the rotation of the casing (don't forget some reverse gearing to make the sum zero for two motors going in the same (...) (26 years ago, 21-Sep-00, to lugnet.robotics)
 
  Re: Short term memory ablut sensor input???
 
(...) never mind. I've done this once, to prove, that you can build a little robot, which won't get stuck in any kind of corner. Changing strategie, if it detects a corner, in which it was stuck. an programm it only with this kid programming (...) (26 years ago, 21-Sep-00, to lugnet.robotics.rcx)
 
  Re: Advice on Rotation sensors and steering please.
 
(...) So you tell your system to drive both motors forward and if you do nothing else then you are only on count off! You must have better matched motors than mine! I see a 10 or 20% difference in their speeds that needs to be corrected to get the (...) (26 years ago, 21-Sep-00, to lugnet.robotics)
 
  Re: Short term memory ablut sensor input???
 
(...) That's true. You can't remember something like a light-sensor reading, though. My thinking is: if you're at the point where you want to be doing stuff like this, you're probably ready to graduate to a better system! (26 years ago, 21-Sep-00, to lugnet.robotics.rcx)
 
  Re: Short term memory ablut sensor input???
 
(...) That's not quite right. It is a little bit weard but you can use the counter to detect different states :) In connection with the timer, you can build a simple time dependent variable but only one. Regards Carsten (26 years ago, 21-Sep-00, to lugnet.robotics.rcx)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR