To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *22349 (-10)
  Re: global output control
 
(...) That sounds like a reason to use it right there. :) (26 years ago, 21-Jun-00, to lugnet.robotics.rcx.nqc)
 
  RE: Lego Weight Elements
 
Hi, Thanks for the info. I basically want to know if I can use these to alter the center of gravity for a biped walking robot. I dont want to move the RCX back and forth.... Ram -----Original Message----- From: news-gateway@lugnet.com (...) (26 years ago, 21-Jun-00, to lugnet.robotics)
 
  Re: global output control
 
(...) Yes it is a great description of the actual function, however I feel the word is a bit obscure and that's why I hesitate about using it. That's what the "not sure" is...Obvert technically means the right thing, but perhaps isn't obvious to (...) (26 years ago, 21-Jun-00, to lugnet.robotics.rcx.nqc)
 
  Dumb VB question
 
If using the constants OUTPUT_A, OUTPUT_B, OUTPUT_C instead of "012" ... how can you refer to multiple outputs in one command? "OUTPUT_AOUTPUT_BOUTPUT_C" certainly doesn't work, and neither do "OUTPUT_A,OUTPUT_B,OUTPUT_C" or "OUTPUT_A OUTPUT_B (...) (26 years ago, 21-Jun-00, to lugnet.robotics.rcx)
 
  Re: Lego Weight Elements
 
"Ram Meenakshisundaram" <rmeenaks@olf.com> wrote in message news:394FD5D4.E29D25...olf.com... (...) 1.9 oz (55 grams) each. They are 2 x 6 x 2 studs in size. -Rob. (26 years ago, 21-Jun-00, to lugnet.robotics)
 
  Re: New to legOS, can you get it seperately?
 
(...) It is free, but it won't do you much good without an RCX- to the best of my knowledge it won't run on anything else. (...) It's not really another type of C- just a different set of libraries. Other than that, same old C. -Luis (...) ---...--- (...) (26 years ago, 21-Jun-00, to lugnet.robotics.rcx.legos)
 
  (canceled)
 
 
  Re: global output control
 
(...) PS -- I'm not really as fanatical about this as I may seem. I'll be happy either way. (26 years ago, 20-Jun-00, to lugnet.robotics.rcx.nqc)
 
  Re: global output control
 
(...) It's a perfectly good word! (It's not in M-W, but OED has it. And M-W has "obverse"....) :) And, it describes exactly what you want. (26 years ago, 20-Jun-00, to lugnet.robotics.rcx.nqc)
 
  Re: global output control
 
(...) I was thinking of RestoreOutput myself, but then I was wondering if it implied restoring the enable/disable state as well. I'd like to keep the calls 'paired' as much as possible... EnableOutput / DisableOutput InvertOutput / ???Output I know (...) (26 years ago, 20-Jun-00, to lugnet.robotics.rcx.nqc)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR