To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *22244 (-5)
  Re: LNP Question
 
Hello Colin, (...) (26 years ago, 14-Jun-00, to lugnet.robotics.rcx.legos)
 
  Re: HB Memory map
 
Device Location Notes ===...=== 6811 internal $0000-$00ff Built-in RAM (A1 chip) $0000-$01ff (E1 chip) ---...--- 6811 control $1000-$103f Built-in registers ---...--- Expansion I/O $4000-$4fff Memory reads in this range enable the Y1 latch selector, (...) (26 years ago, 14-Jun-00, to lugnet.robotics.handyboard)
 
  Re: LNP Question
 
"Colin Ryan" <colin.ryan@cs.tcd.ie> ha scritto nel messaggio news:394758BE.3DEA88....tcd.ie... (...) I'm working to a porting of lnpd for Win32, but it's not finished yet... Bye, Paolo. --- Indecision is the key to flexibility. (26 years ago, 14-Jun-00, to lugnet.robotics.rcx.legos)
 
  Re: Interfacing BASIC Stamp and Lego?
 
In a flee market, I stumbled upon an Swedish electronics magazine with Lego on its cover. Of course, I had to buy it. :) The article's header read: "LightFinder - Controlling Robots using BASIC Stamp". The article is of course in Swedish but if (...) (26 years ago, 14-Jun-00, to lugnet.robotics)
 
  Re: Motors spinning at startup
 
The problem is the same with LEGO-gear-motors. Even worse, the post says "... put a wire to the can ..." but how can you do this with a plastic device? Any help appreciated. Dirk (26 years ago, 14-Jun-00, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR