 | | Re: Variables on Lego Programming
|
|
(...) Nope. Time for NQC. :) (26 years ago, 9-Jun-00, to lugnet.robotics)
|
| |
 | | Re: 9v Gear Motors
|
|
Ah, that's why it changes the speed. The motors have a flywheel so pulses of on/float with no motor load will not appreciably change the motor speed. The inertia of the flywheel keeps the motor running during the float times. However, pulses of (...) (26 years ago, 9-Jun-00, to lugnet.robotics)
|
| |
 | | Variables on Lego Programming
|
|
It is possible to program with variables (x=5, y=8) on the graphic enviroment of RIS? Regards (URL) (26 years ago, 9-Jun-00, to lugnet.robotics)
|
| |
 | | Re: 9v Gear Motors
|
|
Dave, A shorted to B (disconnected from the battery) might work if the motor acts like a generator when you turn it. But you try it. Even the smallest change in angle is resisted and with no spring-back. Un-motor-like. Jerry (...) (26 years ago, 9-Jun-00, to lugnet.robotics)
|
| |
 | | RE: 9v Gear Motors
|
|
Well I guess I'm not too surprised. As has been mentioned, PWM control is much more effective if it is driving a heavy load not a light one. This is exacerbated by the presence of the flywheel. When you turn off the electrical power and float the (...) (26 years ago, 9-Jun-00, to lugnet.robotics)
|
| |
 | | Re: 9v Gear Motors
|
|
I am very surprised to learn that the coded speed control function actually uses "on" and "off" rather than "on" and "float". When the motor is turned "on", it speeds up, consuming substantially more power than it will once it reaches its final full (...) (26 years ago, 9-Jun-00, to lugnet.robotics)
|
| |
 | | Re: 9v Gear Motors
|
|
=>From: "Jerry Kalpin" <jdkalpin@sympatico.ca> =>... =>if there are three states: on, off and float, there must =>be more than 2 terminals in use. No, with two terminals (A & B), you can get: * A positive with respect to B => motor runs in one (...) (26 years ago, 9-Jun-00, to lugnet.robotics)
|
| |
 | | Re: 9v Gear Motors
|
|
Conrad, if there are three states: on, off and float, there must be more than 2 terminals in use. Yes, there is PWM. According to the experts that changes the torque more than the speed. Under no load and a setting of (say) 2 you should see little (...) (26 years ago, 9-Jun-00, to lugnet.robotics)
|
| |
 | | Re: SDL and legOS (was: memory left)
|
|
Luis Villa <liv@duke.edu> wrote in message news:960488287.393fe...uke.edu... (...) productive, (...) Well, it depends of course on what you intend to do with it. If you for example design and implement a protocol of some sort, it's a great (...) (26 years ago, 9-Jun-00, to lugnet.robotics.rcx.legos)
|
| |
 | | two questions
|
|
Hey, everybody. I have two questions, most of which probably can't be understood by most of the readers on this list :( 1) Is there any way that the stack size might be miscalculated by the new, improved makelx? I've experienced a problem where a (...) (26 years ago, 9-Jun-00, to lugnet.robotics.rcx.legos)
|