To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *22179 (-5)
  Motor Masks***
 
Hi , does anyone know if there are specific moter masks already defined for the HB? Or can I just initialize them anywhere there is free memory? Thanks -Mike (26 years ago, 9-Jun-00, to lugnet.robotics.handyboard)
 
  Re: lcd_refresh()- get rid of it?
 
Then I'll put a note in to that effect- can't believe I hadn't noticed that earlier. There are a couple of bugs in config.h, too (in the CONF_X depends on CONF_Y) sections, so I'll just check something in later. Nothing big, just irritating :) -Luis (...) (26 years ago, 9-Jun-00, to lugnet.robotics.rcx.legos)
 
  Re: lcd_refresh()- get rid of it?
 
"Luis Villa" <liv@duke.edu> wrote in message news:FvuEJE.F7I@lugnet.com... (...) Well, it depends on the line: #define CONF_LCD_REFRESH in file boot/config.h. If you comment it out, you still need lcd_refresh()... :-) Bye, Paolo. --- "The pessimist (...) (26 years ago, 8-Jun-00, to lugnet.robotics.rcx.legos)
 
  using the <remote> commmand in NQC
 
Does anyone know where I can find a listing of the 4 digit codes for the <remote> command? Thx, Brandon (26 years ago, 8-Jun-00, to lugnet.robotics.rcx)
 
  Re: 9v Gear Motors
 
Just went back and re-read the book, and in fact the RCX does do pulse width modulation and not voltage amplitude to set different power levels. In which case I'm not sure why effectively doing the same thing in NQC code works any better, but it (...) (26 years ago, 8-Jun-00, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR