To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *21724 (-5)
  RE: hellofriend
 
Yes, definitely spam! | -----Original Message----- | From: Meabadboy@aol.com [mailto:Meabadboy@aol.com] | Sent: Sunday, May 14, 2000 3:48 AM | To: handyboard@media.mit.edu | Subject: Fwd: hellofriend | | | SPAM??? | | (27 years ago, 14-May-00, to lugnet.robotics.handyboard)
 
  using 3v motors?
 
Is there any way to use 3 volt motors on the Handyboard? They draw about 400 ma. Using a series resistor of about 10 ohms works, but it will have to be about 5 watts, consuming a lot of power needlessly. The FAQ shows how to run 6-36v motors through (...) (27 years ago, 14-May-00, to lugnet.robotics.handyboard)
 
  Scout, Microscout & IR Remote
 
My son and I accidently discovered last night that if the Microscout light link input is in range, or fiber optically connected, to the Scouts light link output, then the infrared remote (from the UA kit) "C" buttons can then control the Microscout (...) (27 years ago, 14-May-00, to lugnet.robotics)
 
  lnp communication question
 
Hi! When using lnp_integrity_write(&data, length), what is the length argument used for? The data can only be one byte long if I understand it correctly. Can I use the length argument to send an additional byte of information? Is there anyway I can (...) (27 years ago, 14-May-00, to lugnet.robotics.rcx.legos)
 
  RE: serial port interrupts
 
(...) Sounds good Steve, see notes below for some pointers... (...) Absolutely. All we have to do is enable the interrupts on the receiver throw the chars into a buffer. I'd keep the standard FORTH words that already exist so less system source (...) (27 years ago, 14-May-00, to lugnet.robotics.rcx.pbforth)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR