| |
Is there any way to use 3 volt motors on the Handyboard? They draw about 400 ma.
Using a series resistor of about 10 ohms works, but it will have to be about 5
watts, consuming a lot of power needlessly. The FAQ shows how to run 6-36v
motors through a separate supply. Will this work with 3 volt motors and a 3 volt
supply??
Any ideas are welcome.
thanks,
Wayne
|
|
Message has 1 Reply:
 | | Re: using 3v motors?
|
| In theory yes. Since the motor will be powered by the aux power supply only, as long as it is at 3 volt, it should be OK. (am I right, Prof. Martin?) -- Ray Wayne Crosbie <wcrosbie@home.com> wrote in message news:FuKHs7.B7v@lugnet.com... (...) 400 (...) (25 years ago, 14-May-00, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
