 | | unsubscribe
|
|
unsubscribe (30 years ago, 25-Mar-96, to lugnet.robotics.handyboard)
|
| |
| | digital output
|
|
Is it possible to use any digital output on the Handy Board without loosing the monitor (or anything else for that matter)? Scott sherman@plains.nodak.edu (30 years ago, 25-Mar-96, to lugnet.robotics.handyboard)
|
| |
| | Re: unsubscribe
|
|
In order to be removed from the Handy Board mailing list, please send e-mail directly to me, Fred Martin. There is no need to announce your request to the entire list. Enclosed are instructions from the mailing list page on the web site. -Fred -- (...) (30 years ago, 25-Mar-96, to lugnet.robotics.handyboard)
|
| |
| | Re: pulse trains
|
|
(...) I'm doing signal conditioning for pan/tilt and (ultimately) drive/steer signals from an RC receiver and driving servos with the processed signals. All power for the servos is external, so all I need is signals through the Handyboard. -mike * (...) (30 years ago, 25-Mar-96, to lugnet.robotics.handyboard)
|
| |
| | Re: Get Alias Info
|
|
In your message you said: (...) Arghh! The "get alias info" command is on the web pages, i.e., (URL) everyone, remember there is nothing automated about the handy board mailing list. to get on it, I must manually put you there. to get you off it, i (...) (30 years ago, 25-Mar-96, to lugnet.robotics.handyboard)
|
| |
| | How to run 8 servos by adding one HC chip
|
|
(...) Warning: I haven't tried the following idea. Single chip add-on to control 8 servos using one timer line and a few digital outputs: The 74HC238 is a 3 to 8 demultiplexor. (see (URL) for datasheets). Unlike the more common HC138, its outputs (...) (30 years ago, 26-Mar-96, to lugnet.robotics.handyboard)
|
| |
| | process control question
|
|
Hi all, I used the routines in Mobile Robot as a guide in building routines for my robot. I have an IR detector setup like the one described using the Sharp detector to detect left and right obstacles. I have a round robot with three bumper switches (...) (30 years ago, 26-Mar-96, to lugnet.robotics.handyboard)
|
| |
| | Get Alias Info
|
|
Get Alias Info (30 years ago, 26-Mar-96, to lugnet.robotics.handyboard)
|
| |
| | pneumatic arms
|
|
Since electric motors running off small, mobile power supplies tend to be weak and slow, I was considering designing a pneumatic arm powered by an onboard container of compressed air. Can anyone tell me where I can obtain pneumatic solenoids (...) (30 years ago, 26-Mar-96, to lugnet.robotics.handyboard)
|
| |
| | Re: Sony IR decoding routine!
|
|
I'm having trouble getting sony-ir.icb to load. Every time I try, I get the following error message: FATAL INTERNAL ERROR: ILLEGAL LINE IN .s19 FILE I've re-downloaded and installed both the sony-ir.icb and pcode_hb.s19 files but continure to get (...) (30 years ago, 26-Mar-96, to lugnet.robotics.handyboard)
|
