To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *1886 (+5)
  Re: running 2 IR
 
What you can do is just like the schematic for the built-in IR emitter circuit. You need to either software generate your wave or do it like the schematic. If software generated, this output would come from a output port on the HC11 to a transistor (...) (30 years ago, 9-Apr-97, to lugnet.robotics.handyboard)
 
  Re: running 2 IR
 
(...) Can we not tie two IR LED's in parallel and plug into the IR port on the HB. ? (...) (30 years ago, 9-Apr-97, to lugnet.robotics.handyboard)
 
  Re: pressure sensors... antistatic foam
 
A viable option, depending on what sort of pressure is involved, is to put a thin piece of conductive (ie. antistatic) foam between two metal plates. The resistance between the plates ends up being roughly proportional to the pressure applied. It (...) (30 years ago, 9-Apr-97, to lugnet.robotics.handyboard)
 
  Re: pressure sensors..
 
JM, I don't have the book in front of me but Mobile Robots, From Inspiration to Implementation has some info on just this subject. If you don't have it or can't get access to it let me know and I'll do some research for ya. For example if its touch (...) (30 years ago, 9-Apr-97, to lugnet.robotics.handyboard)
 
  Re: running 2 IR
 
If the IR LEDs both add up to a current requirement of 800ma (the spec on the ztx614) then yes you should be able to. You may want to add a resistor to supply that assures you don't get more than 800ma from supply (if that is Imax for those LEDs). (...) (30 years ago, 9-Apr-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR