 | | Mini SSC - Scott Edwards
|
|
Hi, I am working in a group to make a six legged robot. We are using the Mini SSC from Scott Edwards to control the servo motors. We've connected the digital output #9 from the Handy Board to the S(in)#2 pin of the SSC. We also connected the signal (...) (30 years ago, 4-Apr-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: LCD Panel Substitute
|
|
Any 16x2 LCD with a Hitachi HD44780 controller chip will work. I got mine from wirz electronics at www.wirz.com (go to serial lcd displays and they sell the LCD separate for $8 bucks!) There are lots of displays that use (...) (30 years ago, 4-Apr-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: photo sensor quesion.
|
|
If you have a device that uses the handyboard supply to generate voltages then just voltage divide the output to the correct 0-5v and input on the analog ports. If you are using phototransistors or something similar there are lots of photo circuits (...) (30 years ago, 4-Apr-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: power supply
|
|
I have never done much battery work and I was wondering if using a separate battery with a common ground to the HB has caused anyone any problems during charging or any other situation. I have common grounded a 3v battery pack to the HB supply to (...) (30 years ago, 4-Apr-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: Mini SSC - Scott Edwards
|
|
(...) Stop the presses! You should have gotten documentation with the SSC but since you are apparently missing it (and its small anyway) the relevant information is that the Mini-SSC uses a serial interface to control its servos. You must send down (...) (30 years ago, 4-Apr-97, to lugnet.robotics.handyboard)
|