 | | Re: Digital Outputs
|
|
(...) Adam, Have you thought about using a some of the Motor Chip driver digital output lines(if you don't need two motor driver chips)? If you pull one of the L293 chips you can free up 4 digital output lines very easily. It would, of course, (...) (30 years ago, 31-Mar-97, to lugnet.robotics.handyboard)
|
| |
 | | re: IR frequency / o'scope adjustments
|
|
(...) You want to trigger off of the signal, or maybe the line; the knobs to turn are generally marked "slope" and "level" or something close to this. I usually use a positive slope, I just like the signal to be going in a positive direction at the (...) (30 years ago, 31-Mar-97, to lugnet.robotics.handyboard)
|
| |
 | | LM2931
|
|
Is it allright if I replace the LM2931 on the Handyboard Interface/Charger Unit with 78L05 (same package)? (30 years ago, 31-Mar-97, to lugnet.robotics.handyboard)
|
| |
 | | connecting Scott edwards mini-ssc to handy board
|
|
Hi, Does anyone have any insight to offer on connecting the HB to the scott edwards electronics mini-ssc servo controller? I wanted to connect directly to the HB through the onboard rj12 jack. Looking at the schematics It seems I might be able to (...) (30 years ago, 31-Mar-97, to lugnet.robotics.handyboard)
|
| |
 | | Servo encoder.
|
|
Does anyone see a problem with using the pot in a modified servo and an encoder. I have modified it so that it makes contact once every revolution. Would this mechanical contact create any "bounce" that would interfere with the enoding ticks. (30 years ago, 31-Mar-97, to lugnet.robotics.handyboard)
|