To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *1791 (+5)
  Re: IR for bots
 
Hi Richard, I believe 50% duty cycle of on/off time is just an arbitary number which is easy to implement. You can change to any other number or even can be some sort of coding at the rate that is less than center freq. or carrier (38Khz here). (...) (30 years ago, 28-Mar-97, to lugnet.robotics.handyboard)
 
  Digital Outputs
 
I'm interested in finding more on how I might digitally controll more devices from the HB. From my current knowledge I was thinking it is possible (with some asm code) to drive TTL signals to the unused expansion header via A12 and A13 pins of the (...) (30 years ago, 28-Mar-97, to lugnet.robotics.handyboard)
 
  re: IR frequency
 
How do i find out the frequency of the IR signal emanating from the LED? Just by connecting the leads from the LED to a CRO ? (30 years ago, 28-Mar-97, to lugnet.robotics.handyboard)
 
  IR concept
 
An alternate IR system.... I've been scanning through some of the IR stuff to see if I can't pick out a good solid system for collision avoidance on a short range (approx. 6-10cm) scale, but everything seems like alot of trouble. Some guys at Humber (...) (30 years ago, 28-Mar-97, to lugnet.robotics.handyboard)
 
  Re: IR concept
 
In addition.... Perhaps I could use the on board IR header to turn on the 4 IR diode array with each diode in series with a current limit resistor and in parallel with the IR output header..?? (I think this has been suggested before.) (...) (30 years ago, 28-Mar-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR